0~60°C (Provided that, there should be no freezing)
Scope of application
Powder, Granules, Lumps
Grains, Cement, Sand, Flour
Wheat flour, Soybean, Feed, Sugar, Sand, etc.
Example Of Installation
Precaution For Installation
Check the voltage of the power supply. The built-in small motor requires a predetermined voltage which cannot be adjusted.
Carefully review places to be selected for installation-The wings should not come into contact with parts such as steel piers in silos or tanks -Avoid places where powder drops. Upper limit switches should be installed vertically to have the device exert its performance.
When the switch has been installed outdoors, problems may easily occur in electric piping in particular. If the level switch is lower than the wiring duct as shown in the figure, rainwater many flow into the electric piping and into the main body of the level switch in rainy seasons. Therefore, please pay special attention to this matter.
The level switch is mechanical and has a small built-in synchronous motor(torque: 0.1-1kgf/cm). Therefore, please be careful so that no foreign matter or impurities would go into the level switch while being installed.
If pressure is applied to the diaphragm surface by powder in the silo or tank, the built-in micro-switch will operate due to the force. If there is no powder in the silo or tank, the switch will be automatically restored by the force of the built-in spring. When necessary, the internal spring’s force may be adjusted to adjust the sensitivity.
CautionDo not use this switch in use environments where the rubber diaphragm may be damaged.
ALUMINUM PUMPS AND MOTORS D/H/HD SERIES PUMPS GEROTOR SERIES HP SERIES PGP/PGM 500 SERIES P16 SERIES 20 SERIES 25 SERIES CAST IRON PUMPS AND MOTORS DUMP PUMPS PGP/PGM 020 SERIES PGP/PGM 030/050/075 SERIES PGP/PGM 300 SERIES PGP/PGM 600 SERIES Advertisements
A Parker pressure-loaded gear pump consists of two, intermeshing, hardened-steel, precision-ground gear assemblies. These precision gears are enclosed by a high-strength, die-cast aluminum front cover, back cover and a high-yield, strength-extruded aluminum center section. Features Speeds up to 4000 rpm Pressure-loaded design Efficient, simple design – few moving parts Exceptionally compact and lightweight for their capacity Efficient at high pressure operation […]
Hydraulic Pump Piston Pump Vane Pump Gear Pump Parker salah satu brand hydraulic yang sangat terkenal dan mempunyai jenis hydraulic pump yang cukup lengkap. Parker menawarkan pumpa untuk hydraulic, fuel, oil, fluid transfer, lubrication dan aplikasi untuk aerospace. Pompa parker juga dapat diguanakan untuk sytem terbuka maupun sitem tertutup. Pompa parker mencakup aplikasi yang cukup luas dari dunia industri, mobile […]