The TX100/200-Series are adjustable depth insertion turbines flow sensor that come in brass or 316 stainless models to fit 3” to 40” pipe. Installation fittings are standard 1-1/2″ (101/201) or 2” (115/215) FNPT. Fittings such as saddles and weldolets may be purchased either locally or from Seametrics flow meter.
Ruby bearings and a non-drag pickoff give these adjustable insertion turbine flow sensors a wide flow range and long life. A sensor detects the passage of miniature magnets in the rotor blades. The resulting square-wave signal can be sent for hundreds of feet without a transmitter, over unshielded cable. This signal can be connected directly to many PLC’s and other controls without any additional electronics.
If desired, a modular system of electronics can be installed directly on the flow sensor or mounted remotely. The FT415 (battery powered) or FT420 (loop powered) provides digital rate and total display, as well as programmable pulse; the FT420 also provides a 4-20 mA analog output. The AO55 is a blind analog (4-20 mA) transmitter. Programmable pulse for pump pacing is available with the PD10.
The “hot-tap” models (TX115/215) can be installed or serviced without shutting down the line by means of a 2” full-port isolation valve that comes with a nipple for installation on the pipe fitting. In most circumstances, no special tool is required.
Recent Posts: Flow meters Wiratama
The Rheonik coriolis meters are primarily Mass Flow Meters and they can measure mass very accurately. These two components are RHM coriolis flow sensors and RHE Coriolis Flow Transmitters
Safety solenoid valves for air and gas from delta elektrogas has many models such as VMM, vmh, vmr, vml, and VMRNA
The VMH type valve is a safety shut off valve for gas with a hydraulic actuator. It is suitable for air or gas blocking and releasing controls, required in the main pipe of gas power burners, atmospheric gas boilers, industrial kilns, and others gas-consuming appliances
SHAKO Pneumatics has dedicated its entire resources to the field of pneumatic products and committed its energies to develop and produce new products
An Air Diaphragm Pumps is a type of positive displacement pump that uses compressed air as a power source.
Air Motors are designed to operate by compressed air. For applications, where positive braking is a requirement, a range of caliper brakes is offered.
An air winch is powered by compressed air instead of electricity. The drive mechanism of the air winch will begin to power the cable drum and effectively raising or lowering the attached load
kalibrasi flow meter dimaksudkan untuk mengembalikan performa flow meter guna mendapatkan faktor ketidak pastian pengukuran, yang merupakan akurasi flow meter dengan flow caliberator dan resetting
Dimensi Flange Ansi#150
Valon pressure sensor products, vpr2, vprv-d, VSW2, VPRT, VDP4, VFM, VPRH, VPMC, Pressure Meter