News Topic

gas meter

Thermal Mass Compress air and gas flow meters VA500

Flow sensor for compressed air and gas – VA 500 Contrary to the previously used bridge circuit the newly developed evaluation electronics of our flow sensor records all measured values digitally. This leads to a better accuracy also in case of large measuring spans of 1:1000. What are the advantages of our flow measuring technology? Even more

Thermal Mass Gas Flowmeter

Thermal flowmeters are most commonly used to measure the mass flow of clean gases, such as air, nitrogen, hydrogen, helium, ammonia, argon, and other industrial gases. Mixtures, such as flue stack flow and biogas flow, can be measured when their composition is known. An advantage of this technology is its dependence upon thermal properties that more

Gas Area Flow Meter Kofloc

An area flow meter has a float in a conical cylinder (tapered tube) with a larger end in the upper section and a smaller end in the lower section. The float moves up and down according to the intensity of the flow, and the position at which the float balances indicates the flow rate. Not only simple flow meters that merely measure the flow rate more

Sage 300 Flowmeter Thermal Mass

Sage 300 Thermal Mass Flow Meter The Sage 300 thermal mass flow meter is an economical alternative to the Sage Prime® while offering comparable performance. The meter measures gas mass flow and has the same accuracy, repeatability, low-end sensitivity, response time, turn down and resolution as the Prime without some premium features. If the user more

Oxygen Gas Flow Meter

MF5200 series oxygen flow meters are specially designed for oxygen metering system in a hospital.  These meters are operated with the standard industrial user interfaces (RS485), and user defined alarm functions for better monitoring or control over the network. The off-the-shelf products (MF5212 and MF5219) are for gas flow measurement of 0 ~ more

Insertion Gas Flow Sensor

MFI series insertion mass flow meters are designed for gas monitoring and control in a large pipe line where installation of an in-line flow meter is either difficult or costly. The insertion minimal interruption to the normal working circumstance.  The suggested starting metering DN is 150 mm and above. All of the insertion meters have an more