Ruby bearings and a non-drag pickoff give these adjustable insertion turbine flow sensors a wide flow range and long life. A sensor detects the passage of miniature magnets in the rotor blades. The resulting square-wave signal can be sent for hundreds of feet without a transmitter, over unshielded cable. This signal can be connected directly to many PLC’s and other controls without any additional electronics.
A modular system of electronics can be installed directly on the flow sensor or mounted remotely. The FT430 (externally powered with pulse), FT440 (loop powered), and FT450 (battery powered) all provide digital rate and total displays, as well as a programmable pulse; the FT440 also provides a 4-20 mA analog output. The AO55 is a blind analog (4-20 mA) transmitter. Programmable pulse for pump pacing is available with the PD10.
- Wide flow range
- One moving part
- Hot tap available
- Modular electronics compatible
- Easily depth adjustable for 3-40” pipe
- Clean water
- Large pipes
- Aquariums, water parks
- Water & waste water monitoring
The “hot-tap” models (TX15x/25x) can be installed or serviced without shutting down the line by means of a 2” full-port isolation valve that comes with a nipple for installation on the pipe fitting. In most circumstances, no special tool is required.
Articles: Rudy flow meter Wiratama
Flow meter air baku pdam adalah flow meter yang digunakan untuk mengukur debit air dan total volume air baku yang akan di proses guna menghasilkan kwalitas air sesuai standart pdam. Air baku pdam bisanya dimabil dari sungai, bendungan, waduk atau sumur bor dan untuk daerah tertentu mungkin mengambil dari air laut yang di proses menjadi […]
Flow sensor for compressed air and gas – VA 500 Contrary to the previously used bridge circuit the newly developed evaluation electronics of our flow sensor records all measured values digitally. This leads to a better accuracy also in case of large measuring spans of 1:1000. What are the advantages of our flow measuring technology? […]
Fow meters from CS Instruments work according to the calorimetric measuring principle. This means, while measuring the thermal mass flow or standard volume flow, no additional temperature and pressure compensation is necessary. The standard volume is a common volumetric unit used to compare gas quantities at different pressures and temperatures. In order to meet various […]
The product group “Batch Controllers” offers multiple batch controllers in the N-Series, F-Series and D-Series product ranges. The batch controllers can be used for accurate dispensing of small amounts of liquids up to the loading of trucks with two-stage control and analog multi-stage control. Specially designed for the delivery of unknown quantities of product is […]
The product group “Flow Computers” offers a unique range of comprehensive solutions to calculate the consumption and net flow at standard conditions or the ratio between two flows. Typical applications are found on board of ships to calculate the fuel consumption, gas flow calculation in power plants and the monitoring of two component blending. The […]