Advertisements
News Topic

TDS-100H Portable Ultrasonic Flow Meters

 

The TDS-100H ultrasonic flow meter is designed to measure the fluid velocity of liquid within a closed conduit.  The transducers are a non-contacting, clamp-on type, which will provide benefits of non-fouling operation and easy installation. The TDS-100H transit time flow meter utilizes two  transducers that function as both ultrasonic transmitters and receivers. The transducers are clamped on the outside of a closed pipe at a specific distance from each other.  The transducers can be mounted in V-method where the sound transverses the pipe twice, or W-method where the sound transverses the pipe four times, or in Z-method where the transducers are mounted on opposite sides of the pipe and the sound crosses the pipe once.  This selection of the mounting method depends on pipe and liquid characteristics.  The flow meter operates by alternately transmitting and receiving a frequency modulated burst of sound energy between the two transducers and measuring the transit time that it takes for sound to travel between the two transducers.  The difference in the transit time measured is directly and exactly related to the velocity of the liquid in the pipe

TDS series Handhold Ultrasonic Flow Meters are based on clamp-on transit-time flow measurement principle. It measures the flow rate of liquid in a pipe from outside of the pipe by using a pair of ultrasonic transducers. In general, the liquid should be full in the pipe, and should contain very little particles or bubbles. It is applicable for water (hot water, chill water, city water, sea water, etc.); sewage; oil (crude oil, lubricating oil, diesel oil, fuel oil, etc.); chemicals (alcohol, acids, etc.); waste; beverage and liquid food, solvents and other liquids.TDS-100H handheld ultrasonic flow meter is a battery-powered ultrasonic flow meter with the capability of a full-size flow meter. It is carefully designed for portability and ease of use.

 

 

Technical Specification:

Linearity : 0.5%
Repeatability : 0.2%
Accuracy : ±1% of reading at rates>0.2 mps
Response Time : 0-999 seconds, user-configurable
Velocity : ±32 m/s
Pipe Size : 20mm-6000mm
Rate Units : Meter, Feet, Cubic Meter, Liter, Cubic Feet, USA Gallon, Imperial Gallon, Oil Barrel, USA Liquid Barrel, Imperial Liquid Barrel, Million USA Gallons. User configurable.
Totalizer : 7-digit totals for net, positive and negative flow respectively
Liquid Types : Virtually all liquids
Security : Setup values Modification Lockout. Access code needs unlocking
Display : 4×16 English letters
Communication Interface : RS-232C, baud-rate: from 75 to 57600. Protocol made by the manufacturer and  compatible with that of the FUJI ultrasonic flow meter. User protocols can be made on enquiry.
Transducers : Model M1 for standard, other 3 models for optional
Transducer Cord Length : Standard 2×10 meters, optional 2x 500 meters
Power Supply : 3 AAA Ni-H built-in batteries. When fully recharged it will last over 10 hours of operation.100V-240VAC for the charger
Data Logger : Built-in data logger can store over 2000 lines of data
Manual Totalizer : 7-digit press-key-to-go totalizer for calibration
Housing Material : ABS
Case Size : 100x66x20mm
Handset Weight : 514g (1.2 lbs) with batteries
Advertisements

Articles: Rudy flow meter Wiratama

Flow Meter Air Baku PDAM

Flow meter air baku pdam adalah flow meter yang digunakan untuk mengukur debit air dan total volume air baku yang akan di proses guna menghasilkan kwalitas air sesuai standart pdam. Air baku pdam bisanya dimabil dari sungai, bendungan, waduk atau sumur bor dan untuk daerah tertentu mungkin mengambil dari air laut yang di proses menjadi […]

Thermal Mass Compress air and gas flow meters VA500

Flow sensor for compressed air and gas – VA 500 Contrary to the previously used bridge circuit the newly developed evaluation electronics of our flow sensor records all measured values digitally. This leads to a better accuracy also in case of large measuring spans of 1:1000. What are the advantages of our flow measuring technology? […]

Flow meters for compressed air and gas

Fow meters from CS Instruments work according to the calorimetric measuring principle. This means, while measuring the thermal mass flow or standard volume flow, no additional temperature and pressure compensation is necessary. The standard volume is a common volumetric unit used to compare gas quantities at different pressures and temperatures. In order to meet various […]

Batch Controller N series fluidwell

The product group “Batch Controllers” offers multiple batch controllers in the N-Series, F-Series and D-Series product ranges. The batch controllers can be used for accurate dispensing of small amounts of liquids up to the loading of trucks with two-stage control and analog multi-stage control. Specially designed for the delivery of unknown quantities of product is […]

Flow Computers fluidwell

The product group “Flow Computers” offers a unique range of comprehensive solutions to calculate the consumption and net flow at standard conditions or the ratio between two flows. Typical applications are found on board of ships to calculate the fuel consumption, gas flow calculation in power plants and the monitoring of two component blending. The […]

 

Ada yang ingin ditanyakan silahkan

1. Jika ada Pertanyaan tentang Product ataupun harga silahkan langsung hubungi :

2.  Jika ada pertanyaan atau diskusi Tentang tulisan disini silahkan email ke :            admin@rudywinoto.com

  Atau silahkan isi kolom dibawah ini dan klik submit      

  Flowmagflowmasonic          

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: