Electrode Level sensor
- It is used in the conductive liquid level measurement.
- It is widely used in the sewage or wastewater tanks
- When using in a chemical plant, it is possible to be used by having a PTFE coating on the electrode (selection specification)
- Since it is possible to have 2line type, the wiring work is simple and the construction cost can be saved.
- The installation and handling are simple.
- It is possible to consecutively control the motors as many as wanted
It is used in the wastewater and water-purifying tanks.
It is widely used in deep tubular well pumps.
It is used in food and beverage tanks.
It is used in underground water tanks and high water tanks.
It is used in drainage tanks
It is used in various water tanks.
The installation is quick and simple.
- When the liquid level increases or decreases as the power supplied to the unit are connected to a sensor, a relay installed to the unit allows the water supply and piping to operate automatically.
- It is also possible to check the low water level or high water level warnings. It is equipped with an ability to have set control (consecutive control of) 3 motors.
Articles: Rudy flow meter Wiratama
Flow meter air baku pdam adalah flow meter yang digunakan untuk mengukur debit air dan total volume air baku yang akan di proses guna menghasilkan kwalitas air sesuai standart pdam. Air baku pdam bisanya dimabil dari sungai, bendungan, waduk atau sumur bor dan untuk daerah tertentu mungkin mengambil dari air laut yang di proses menjadi […]
Flow sensor for compressed air and gas – VA 500 Contrary to the previously used bridge circuit the newly developed evaluation electronics of our flow sensor records all measured values digitally. This leads to a better accuracy also in case of large measuring spans of 1:1000. What are the advantages of our flow measuring technology? […]
Fow meters from CS Instruments work according to the calorimetric measuring principle. This means, while measuring the thermal mass flow or standard volume flow, no additional temperature and pressure compensation is necessary. The standard volume is a common volumetric unit used to compare gas quantities at different pressures and temperatures. In order to meet various […]
The product group “Batch Controllers” offers multiple batch controllers in the N-Series, F-Series and D-Series product ranges. The batch controllers can be used for accurate dispensing of small amounts of liquids up to the loading of trucks with two-stage control and analog multi-stage control. Specially designed for the delivery of unknown quantities of product is […]
The product group “Flow Computers” offers a unique range of comprehensive solutions to calculate the consumption and net flow at standard conditions or the ratio between two flows. Typical applications are found on board of ships to calculate the fuel consumption, gas flow calculation in power plants and the monitoring of two component blending. The […]